TI TXS0104EPWR

This 4-bit non-inverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 V to 3.6 V. VCCA must be less than or equal to VCCB. The B port is designed to track VCCB. VCCB accepts any supply voltage from 2.3 V to 5.5 V. This allows for low-voltage bidirectional translation between any of the 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. When the output-enable (OE) input is low, all outputs are placed in the high-impedance state. The TXS0104E is designed so that the OE input circuit is supplied by VCCA. To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.

• No Direction-Control Signal Needed
• Max Data Rates:
  • 24 Mbps (Push Pull)
  • 2 Mbps (Open Drain)
• Available in the Texas Instruments NanoFree Package
• 1.65 V to 3.6 V on A port and 2.3 V to 5.5 V on B port (VCCA ≤ VCCB)
• No Power-Supply Sequencing Required, VCCA or VCCB Can Be Ramped First
• Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
• ESD Protection Exceeds JESD 22:
  • A Port:
    • 2000-V Human-Body Model (A114-B)
    • 200-V Machine Model (A115-A)
    • 1000-V Charged-Device Model (C101)
  • B Port:
    • 15 kV Human-Body Model (A114-B)
    • 200-V Machine Model (A115-A)
    • 1000-V Charged-Device Model (C101)
• IEC 61000-4-2 ESD (B Port):
  • ±8-kV Contact Discharge
  • ±10-kV Air-Gap Discharge

• Handset
• Smartphone
• Tablet
• Desktop PC