ST STSPIN32G0601Q

STSPIN32G0601 is a system-in-package offering an integrated solution for driving three-phase applications. It integrates a microcontroller and a 600 V three-phase half-bridge gate driver capable of driving N-channel power MOSFETs or IGBTs. The device incorporates a comparator with advanced smart shutdown functionality, ensuring fast and effective protection against overload and overcurrent conditions. High-voltage bootstrap diodes are also integrated, along with interlocking, dead time, and undervoltage lockout protection in both the low-side and high-side driver sections, preventing the power switches from operating under inefficient or hazardous conditions. Matched propagation delays between the high- and low-side sections guarantee distortion-free cycles. The integrated microcontroller is based on a high-performance 32-bit Arm Cortex-M0+ core running at up to 64 MHz and features a memory protection unit for enhanced application safety. This microcontroller is ideally suited for advanced motor control applications, offering a comprehensive feature set including a 12-bit ADC, an internal voltage reference buffer, one general-purpose 32-bit timer, one 16-bit PWM timer dedicated to motor control, four general-purpose 16-bit timers, two 16-bit low-power timers, and a 5-channel DMA controller capable of performing data transfers between memory-mapped peripherals and/or memories to offload the CPU. It also integrates high-speed memory with multiple protection mechanisms, up to 32 available GPIO ports, major interfaces, a comprehensive set of power-saving modes, and an independent analog power supply input for the ADC. This feature-rich microcontroller enables field-oriented control with single, dual, or triple shunt resistors or sensorless configurations, as well as more conventional six-step control modes. The STSPIN32G0601 also features a complete protection set and an extended operating temperature range, guaranteeing reliable operation even in the most demanding industrial applications. A serial wire debug interface is provided for microcontroller firmware programming and debugging.

• Three-phase gate driver
• High-side rail up to 600 V
• dV/dt transient immunity ±50 V/ns
• Gate drive voltage range 9 V to 20 V
• Drive current capability: source/sink 200/350 mA at 25 °C
• 32-bit ARM Cortex-M0+ microcontroller core: clock frequency up to 64 MHz
• 8 KB SRAM with hardware parity
• 64 KB flash with protection and encryptable region
• CRC calculation unit
• Up to 32 general-purpose I/Os
• 1× 16-bit advanced timer for motor control with up to 6 PWM channels
• 5× general-purpose timers
• 2× low-power timers
• 12-bit ADC with 2 MSps conversion rate
• 5-channel DMA controller with flexible mapping
• Internal high-accuracy voltage reference
• Full interface set: 2× I²C, 2× SPI, 3× UART, and 1× low-power UART
• Matched propagation delay across all channels
• Integrated bootstrap diode
• Comparator for fast overcurrent protection
• UVLO, interlocking, and dead-time features
• Smart shutdown function
• Standby mode for low-power operation
• On-chip debug support via Serial Wire Debug
• Extended temperature range: -40 to +125 °C
• QFN 10×10 72L 0.5 mm pitch, 1.8 mm creepage distance package

• Three-phase motor drivers
• Inverters
• Industrial equipment and fans