MAXIM DS2482S-100+T&R

The DS2482-100 is an I2C-to-1-Wire bridge device that interfaces directly to standard (100kHz max) or fast (400kHz max) I2C masters to perform bidirectional protocol conversion between the I2C master and any downstream 1-Wire slave devices. Relative to any attached 1-Wire slave device, the DS2482-100 is a 1-Wire master. Internal, factory-trimmed timers relieve the system host processor from generating time-critical 1-Wire waveforms, supporting both standard and overdrive 1-Wire communication speeds. To optimize 1-Wire waveform generation, the DS2482-100 performs slew-rate control on rising and falling 1-Wire edges and provides additional programmable features to match drive characteristics to the 1-Wire slave environment. Programmable, strong pullup features support 1-Wire power delivery to 1-Wire devices such as EEPROMs and sensors. The DS2482-100 combines these features with an output to control an external MOSFET for enhanced strong pullup application. The I2C slave address assignment is controlled by two binary address inputs, resolving potential conflicts with other I2C slave devices in the system.

• Allows Easy Interface Between a I2C Microport and a 1-Wire Slave
• I2C Host Interface Supports 100kHz and 400kHz I2C Communication Speeds
• 1-Wire Master IO with Selectable Active or Passive 1-Wire Pullup
• Provides Reset/Presence, 8-Bit, Single-Bit, and 3-Bit 1-Wire IO Sequences
• Standard and Overdrive 1-Wire Communication Speeds
• Two Address Inputs for I2C Address Assignment
• Minimizes Line Noise Reducing System EMI
• Slew-Controlled 1-Wire Edges
• Supports EEPROMs, Temperature Sensors, or Other 1-Wire Slaves That Have Momentary High Source Current Modes
• Strong 1-Wire Pullup Provided by an Internal LowImpedance Signal Path
• PCTLZ Output to Optionally Control an External MOSFET for Stronger Pullup Requirements
• Operating Range: 2.9V to 5.5V, -40°C to +85°C
• 8-Pin (150 mils) SO and 9-Bump WLP Packages

• Printers
• Industrial Sensors
• Medical Instruments
• Cell Phones, PDAs