MICROCHIP LAN9254-I/JRX
| Manufacturer | |
| MPN | LAN9254-I/JRX |
| LCSC Part # | C3229143 |
| Packaging | TQFP-80-EP(12x12) |
| Customer # | |
| Key Attributes | LAN9254 2/3-Port EtherCAT? Slave Controller with Integrated Ethernet PHYs and Demultiplexed HBI / 32 DIGIOs |
| Datasheet | MICROCHIP LAN9254-I/JRX |
| RoHS Compliance | 2 documents available |
Products Specifications
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Controllers | |
| Manufacturer | MICROCHIP | |
| Packaging | TQFP-80-EP(12x12) | |
| Features | Wake-up function;Power-up/reset configuration;Non-volatile configuration storage;Interrupt generation | |
| Voltage - Supply | 1.8V~3.3V | |
| Operating Temperature | -40℃~+85℃ | |
| Quiescent Supply Current | - | |
| Current - Supply | - | |
| Data Rate | 100Mbps | |
| Interface | Bus |
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Controllers | |
| Manufacturer | MICROCHIP | |
| Packaging | TQFP-80-EP(12x12) | |
| Features | Wake-up function;Power-up/reset configuration;Non-volatile configuration storage;Interrupt generation | |
| Voltage - Supply | 1.8V~3.3V |
| Type | Description | |
|---|---|---|
| Operating Temperature | -40℃~+85℃ | |
| Quiescent Supply Current | - | |
| Current - Supply | - | |
| Data Rate | 100Mbps | |
| Interface | Bus |
Introduction
The LAN9254 is a 2/3-port EtherCAT slave controller with dual integrated Ethernet PHYs, each containing a full-duplex 100BASE-TX transceiver that supports 100Mbps (100BASE-TX) operation. The LAN9254 supports HP Auto-MDIX, allowing the use of direct connect or cross-over LAN cables. EtherCAT P and Signal Quality Index PHY diagnostics are supported. The LAN9254 includes an EtherCAT slave controller with 8K bytes of Dual Port memory (DPRAM) and 8 Fieldbus Memory Management Units (FMMUs). Each FMMU performs the task of mapping logical addresses to physical addresses. The EtherCAT slave controller also includes 8 SyncManagers to allow the exchange of data between the EtherCAT master and the local application. Each SyncManager's direction and mode of operation is configured by the EtherCAT master. Two modes of operation are available: buffered mode or mailbox mode. In the buffered mode, both the local microcontroller and EtherCAT master can write to th
Features
- 2/3-port EtherCAT slave controller with 8 Fieldbus Memory Management Units (FMMUs) and 8 SyncManagers
- Interfaces to most 8/16-bit embedded controllers and 32-bit embedded controllers with an 8/16-bit bus
- Integrated Ethernet PHYs with HP Auto-MDIX
- Wake on LAN (WoL) support
- Low power mode allows systems to enter sleep mode until addressed by the Master
- Cable diagnostic support
- 1.8V to 3.3V variable voltage I/O
- Integrated 1.2V regulator for single 3.3V operation
- Integrated high-performance 100Mbps Ethernet transceivers - Compliant with IEEE 802.3/802.3u (Fast Ethernet) - Signal Quality Index diagnostics - Loop-back modes - Automatic polarity detection and correction - HP Auto-MDIX - Compatible with EtherCAT P
- EtherCAT slave controller - Supports 8 FMMUs - Supports 8 SyncManagers - Distributed clock support allows synchronization with other EtherCAT devices - 8K bytes of DPRAM
- 8/16-Bit Host Bus Interface - Indexed register, multiplexed or demultiplexed bus - Allows local host to enter sleep mode until addressed by EtherCAT Master - SPI / SQI (Quad SPI) support
- Digital I/O Mode for optimized system cost - 32 available Digital I/Os
- 3rd port for flexible network configurations
- Comprehensive power management features - 3 power-down levels - Wake on link status change (energy detect) - Magic packet wakeup, Wake on LAN (WoL), wake on broadcast, wake on perfect DA - Wakeup indicator event signal
- Power and I/O - Integrated power-on reset circuit - Latch-up performance exceeds 150mA per EIA/JESD78, Class II - JEDEC Class 3A ESD performance - Single 3.3V power supply (integrated 1.2V regulator)
- Additional Features - EEPROM emulation - Transformer-less link support - Multifunction GPIOs - Ability to use low cost 25MHz crystal for reduced BOM - 25MHz clock output for reference clock daisy chaining
- Packaging - Pb-free RoHS compliant 80-pin TQFP-EP
- Available in commercial, industrial, and extended industrial temp. ranges
Applications
- Motor Motion Control
- Process/Factory Automation
- Communication Modules, Interface Cards
- Sensors
- Hydraulic & Pneumatic Valve Systems
- Operator Interfaces
Products Specifications
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Controllers | |
| Manufacturer | MICROCHIP | |
| Packaging | TQFP-80-EP(12x12) | |
| Features | Wake-up function;Power-up/reset configuration;Non-volatile configuration storage;Interrupt generation | |
| Voltage - Supply | 1.8V~3.3V | |
| Operating Temperature | -40℃~+85℃ | |
| Quiescent Supply Current | - | |
| Current - Supply | - | |
| Data Rate | 100Mbps | |
| Interface | Bus |
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Controllers | |
| Manufacturer | MICROCHIP | |
| Packaging | TQFP-80-EP(12x12) | |
| Features | Wake-up function;Power-up/reset configuration;Non-volatile configuration storage;Interrupt generation | |
| Voltage - Supply | 1.8V~3.3V |
| Type | Description | |
|---|---|---|
| Operating Temperature | -40℃~+85℃ | |
| Quiescent Supply Current | - | |
| Current - Supply | - | |
| Data Rate | 100Mbps | |
| Interface | Bus |
Introduction
The LAN9254 is a 2/3-port EtherCAT slave controller with dual integrated Ethernet PHYs, each containing a full-duplex 100BASE-TX transceiver that supports 100Mbps (100BASE-TX) operation. The LAN9254 supports HP Auto-MDIX, allowing the use of direct connect or cross-over LAN cables. EtherCAT P and Signal Quality Index PHY diagnostics are supported. The LAN9254 includes an EtherCAT slave controller with 8K bytes of Dual Port memory (DPRAM) and 8 Fieldbus Memory Management Units (FMMUs). Each FMMU performs the task of mapping logical addresses to physical addresses. The EtherCAT slave controller also includes 8 SyncManagers to allow the exchange of data between the EtherCAT master and the local application. Each SyncManager's direction and mode of operation is configured by the EtherCAT master. Two modes of operation are available: buffered mode or mailbox mode. In the buffered mode, both the local microcontroller and EtherCAT master can write to th
Features
- 2/3-port EtherCAT slave controller with 8 Fieldbus Memory Management Units (FMMUs) and 8 SyncManagers
- Interfaces to most 8/16-bit embedded controllers and 32-bit embedded controllers with an 8/16-bit bus
- Integrated Ethernet PHYs with HP Auto-MDIX
- Wake on LAN (WoL) support
- Low power mode allows systems to enter sleep mode until addressed by the Master
- Cable diagnostic support
- 1.8V to 3.3V variable voltage I/O
- Integrated 1.2V regulator for single 3.3V operation
- Integrated high-performance 100Mbps Ethernet transceivers - Compliant with IEEE 802.3/802.3u (Fast Ethernet) - Signal Quality Index diagnostics - Loop-back modes - Automatic polarity detection and correction - HP Auto-MDIX - Compatible with EtherCAT P
- EtherCAT slave controller - Supports 8 FMMUs - Supports 8 SyncManagers - Distributed clock support allows synchronization with other EtherCAT devices - 8K bytes of DPRAM
- 8/16-Bit Host Bus Interface - Indexed register, multiplexed or demultiplexed bus - Allows local host to enter sleep mode until addressed by EtherCAT Master - SPI / SQI (Quad SPI) support
- Digital I/O Mode for optimized system cost - 32 available Digital I/Os
- 3rd port for flexible network configurations
- Comprehensive power management features - 3 power-down levels - Wake on link status change (energy detect) - Magic packet wakeup, Wake on LAN (WoL), wake on broadcast, wake on perfect DA - Wakeup indicator event signal
- Power and I/O - Integrated power-on reset circuit - Latch-up performance exceeds 150mA per EIA/JESD78, Class II - JEDEC Class 3A ESD performance - Single 3.3V power supply (integrated 1.2V regulator)
- Additional Features - EEPROM emulation - Transformer-less link support - Multifunction GPIOs - Ability to use low cost 25MHz crystal for reduced BOM - 25MHz clock output for reference clock daisy chaining
- Packaging - Pb-free RoHS compliant 80-pin TQFP-EP
- Available in commercial, industrial, and extended industrial temp. ranges
Applications
- Motor Motion Control
- Process/Factory Automation
- Communication Modules, Interface Cards
- Sensors
- Hydraulic & Pneumatic Valve Systems
- Operator Interfaces
C3229143 EasyEDA Library
Compliance & Export Codes
| Type | Details |
|---|---|
| RoHS | ROHS3 Compliant |
| ECCN | EAR99 |
| CNHTS | 8542399000 |
| USHTS | 8542390001 |
| TARIC | 8542399000 |
| CAHTS | 8542390000 |
| BRHTS | 85423999 |
| INHTS | 85423900 |
| MXHTS | 8542.39.99 |
| Type | Details |
|---|---|
| RoHS | ROHS3 Compliant |
| ECCN | EAR99 |
| CNHTS | 8542399000 |
| USHTS | 8542390001 |
| TARIC | 8542399000 |
| Type | Details |
|---|---|
| CAHTS | 8542390000 |
| BRHTS | 85423999 |
| INHTS | 85423900 |
| MXHTS | 8542.39.99 |

