TI TLIN10283SDRQ1
| Manufacturer | |
| MPN | TLIN10283SDRQ1 |
| LCSC Part # | C2878335 |
| Packaging | SOIC-8 |
| Customer # | |
| Key Attributes | Automotive 70mA System Basis Chip (SBC) |
| Datasheet | TI TLIN10283SDRQ1 |
| RoHS Compliance | 2 documents available |
| Alternative Parts | 1 |
Products Specifications
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Drivers, Receivers, Transceivers | |
| Manufacturer | TI | |
| Packaging | SOIC-8 | |
| Type | Transceiver | |
| Voltage - Supply | 5.5V~28V | |
| number of channels | 1 | |
| Data Rate | 100Kbps | |
| Operating Temperature | -40℃~+150℃ | |
| ESD Protect | ±8kV | |
| Features | Local wake-up;Bus wake-up;Low-power mode;Bus fault protection;Thermal shutdown protection;Under-voltage detection;TXD timeout protection | |
| Supply Current | 5mA | |
| Quiescent Supply Current | 55uA |
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Drivers, Receivers, Transceivers | |
| Manufacturer | TI | |
| Packaging | SOIC-8 | |
| Type | Transceiver | |
| Voltage - Supply | 5.5V~28V | |
| number of channels | 1 |
| Type | Description | |
|---|---|---|
| Data Rate | 100Kbps | |
| Operating Temperature | -40℃~+150℃ | |
| ESD Protect | ±8kV | |
| Features | Local wake-up;Bus wake-up;Low-power mode;Bus fault protection;Thermal shutdown protection;Under-voltage detection;TXD timeout protection | |
| Supply Current | 5mA | |
| Quiescent Supply Current | 55uA |
Introduction
The TLIN1028S-Q1 is a Local Interconnect Network (LIN) physical layer transceiver that complies with the LIN 2.2A ISO/DIS 17987–4 standard and features an integrated Low Dropout (LDO) regulator. LIN is a single-wire, bidirectional bus commonly used in low-speed in-vehicle networks with a data transfer rate of up to 20 kbps. The LIN receiver supports offline programming applications with a data transfer rate of up to 100 kbps.
The TLIN1028S-Q1 converts the LIN protocol data stream on the TXD input into a LIN bus signal. The receiver converts the data stream into a logic-level signal, which is sent to the microprocessor via the open-drain RXD pin. The TLIN1028S-Q1 reduces system complexity by providing a 3.3V or 5V voltage rail with a current of up to 70 mA for power microprocessors, sensors, or other devices.
The TLIN1028S-Q1 features an optimized current-limiting waveform shaping driver to reduce Electromagnetic Emission (EME). The sleep mode enables ultra-low current consumption and allows wake-up via the LIN bus or pin.
The LIN bus has two states: the dominant state (voltage close to ground) and the recessive state (voltage close to the battery). In the recessive state, the LIN bus is pulled high by an internal pull-up resistor (45 kΩ) and a series diode, so no external pull-up components are required for responder mode applications. According to the LIN specification, controller applications require an external pull-up resistor (1 kΩ) plus a series diode.
Features
- AEC-Q100 (Grade 1): compliant with automotive applications, LIN physical layer specification ISO/DIS17987-4, and SAE J2602 recommended practice for LIN
- Functional safety support
- Wide operating range for 12V applications
- ±58V LIN bus fault protection
- LDO output supporting 3.3V or 5V
- Sleep mode: ultra-low current consumption, wake-up via LIN bus or EN pin
- Glitch-free power-up and power-down operation
- ESD protection, VSUP undervoltage protection, TXD dominant timeout (DTO) protection, thermal shutdown, system-level unpowered node or ground disconnect fault protection
- VCC supply up to 70mA
- SOIC (8) package
Applications
- Body electronics and lighting
- Hybrid, electric, and powertrain systems
- Automotive infotainment systems and instrument clusters
- Appliances
| Qty | Unit Price | Total Amount |
|---|---|---|
| 1+ | $ 2.0257 | $ 2.03 |
| 10+ | $ 1.9755 | $ 19.76 |
| 30+ | $ 1.9404 | $ 58.21 |
| 100+ | $ 1.9069 | $ 190.69 |
Standard Packaging2500/Full Reel | ||
Products Specifications
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Drivers, Receivers, Transceivers | |
| Manufacturer | TI | |
| Packaging | SOIC-8 | |
| Type | Transceiver | |
| Voltage - Supply | 5.5V~28V | |
| number of channels | 1 | |
| Data Rate | 100Kbps | |
| Operating Temperature | -40℃~+150℃ | |
| ESD Protect | ±8kV | |
| Features | Local wake-up;Bus wake-up;Low-power mode;Bus fault protection;Thermal shutdown protection;Under-voltage detection;TXD timeout protection | |
| Supply Current | 5mA | |
| Quiescent Supply Current | 55uA |
| Type | Description | |
|---|---|---|
| Category | Integrated Circuits (ICs)/Interface/Drivers, Receivers, Transceivers | |
| Manufacturer | TI | |
| Packaging | SOIC-8 | |
| Type | Transceiver | |
| Voltage - Supply | 5.5V~28V | |
| number of channels | 1 |
| Type | Description | |
|---|---|---|
| Data Rate | 100Kbps | |
| Operating Temperature | -40℃~+150℃ | |
| ESD Protect | ±8kV | |
| Features | Local wake-up;Bus wake-up;Low-power mode;Bus fault protection;Thermal shutdown protection;Under-voltage detection;TXD timeout protection | |
| Supply Current | 5mA | |
| Quiescent Supply Current | 55uA |
Introduction
The TLIN1028S-Q1 is a Local Interconnect Network (LIN) physical layer transceiver that complies with the LIN 2.2A ISO/DIS 17987–4 standard and features an integrated Low Dropout (LDO) regulator. LIN is a single-wire, bidirectional bus commonly used in low-speed in-vehicle networks with a data transfer rate of up to 20 kbps. The LIN receiver supports offline programming applications with a data transfer rate of up to 100 kbps.
The TLIN1028S-Q1 converts the LIN protocol data stream on the TXD input into a LIN bus signal. The receiver converts the data stream into a logic-level signal, which is sent to the microprocessor via the open-drain RXD pin. The TLIN1028S-Q1 reduces system complexity by providing a 3.3V or 5V voltage rail with a current of up to 70 mA for power microprocessors, sensors, or other devices.
The TLIN1028S-Q1 features an optimized current-limiting waveform shaping driver to reduce Electromagnetic Emission (EME). The sleep mode enables ultra-low current consumption and allows wake-up via the LIN bus or pin.
The LIN bus has two states: the dominant state (voltage close to ground) and the recessive state (voltage close to the battery). In the recessive state, the LIN bus is pulled high by an internal pull-up resistor (45 kΩ) and a series diode, so no external pull-up components are required for responder mode applications. According to the LIN specification, controller applications require an external pull-up resistor (1 kΩ) plus a series diode.
Features
- AEC-Q100 (Grade 1): compliant with automotive applications, LIN physical layer specification ISO/DIS17987-4, and SAE J2602 recommended practice for LIN
- Functional safety support
- Wide operating range for 12V applications
- ±58V LIN bus fault protection
- LDO output supporting 3.3V or 5V
- Sleep mode: ultra-low current consumption, wake-up via LIN bus or EN pin
- Glitch-free power-up and power-down operation
- ESD protection, VSUP undervoltage protection, TXD dominant timeout (DTO) protection, thermal shutdown, system-level unpowered node or ground disconnect fault protection
- VCC supply up to 70mA
- SOIC (8) package
Applications
- Body electronics and lighting
- Hybrid, electric, and powertrain systems
- Automotive infotainment systems and instrument clusters
- Appliances
C2878335 EasyEDA Library
Compliance & Export Codes
| Type | Details |
|---|---|
| RoHS | ROHS3 Compliant |
| ECCN | EAR99 |
| CNHTS | 8542399000 |
| USHTS | 8542390001 |
| TARIC | 8542399000 |
| CAHTS | 8542390000 |
| BRHTS | 85423999 |
| INHTS | 85423900 |
| MXHTS | 8542.39.99 |
| Type | Details |
|---|---|
| RoHS | ROHS3 Compliant |
| ECCN | EAR99 |
| CNHTS | 8542399000 |
| USHTS | 8542390001 |
| TARIC | 8542399000 |
| Type | Details |
|---|---|
| CAHTS | 8542390000 |
| BRHTS | 85423999 |
| INHTS | 85423900 |
| MXHTS | 8542.39.99 |
Alternative Parts
| MPN | Manufacturer | Packaging | Availability | Unit Price | ||
|---|---|---|---|---|---|---|
| CA-IF10283S-Q1 | Chipanalog | SOIC-8 | 0 | $ 0.5018 |