TI TMAG5273B1QDBVR

The TMAG5273 is a low-power linear 3D Hall-effect sensor designed for a wide range of industrial and personal electronics applications. This device integrates three independent Hall-effect sensors in the X, Y, and Z axes. A precision analog signalchain along with an integrated 12-bit ADC digitizes the measured analog magnetic field values. The I²C interface, while supporting multiple operating VCC ranges, ensures seamless data communication with low-voltage microcontrollers. The device has an integrated temperature sensor available for multiple system functions, such as thermal budget check or temperature compensation calculation for a given magnetic field. The TMAG5273 can be configured through the I²C interface to enable any combination of magnetic axes and temperature measurements. Additionally, the device can be configured to various power options (including wake-up and sleep mode) allowing designers to optimize system power consumption based on their system-level needs. Multiple sensor conversion schemes and I²C read frames help optimize throughput and accuracy. A dedicated INT pin can act as a system interrupt during low power wake-up and sleep mode, and can also be used by a microcontroller to trigger a new sensor conversion. An integrated angle calculation engine (CORDIC) provides full 360° angular position information for both on-axis and off-axis angle measurement topologies. The angle calculation is performed using two user-selected magnetic axes. The device features magnetic gain and offset correction to mitigate the impact of system mechanical error sources. The TMAG5273 is offered in four different factory-programmed I²C addresses. The device also supports additional I²C addresses through the modification of a user-configurable I²C address register. Each orderable part can be configured to select one of two magnetic field ranges that suits the magnet strength and component placement during system calibration. The device performs consistently across a wide ambient temperature range of -40℃ to +125℃.

• Configurable power modes including:
  • 2.3 mA active mode current
  • 1 μA wake-up and sleep mode current
  • 5 nA sleep mode current
• Selectable linear magnetic range at X, Y, or Z axis:
  • TMAG5273x1: ±40 mT, ±80 mT
  • TMAG5273x2: ±133 mT, ±266 mT
• Interrupt signal from user-defined magnetic and temperature threshold cross
• 5% (typical) sensitivity drift
• Integrated angle CORDIC calculation with gain and offset adjustment
• 20 kSPS single axis conversion rate
• Configurable averaging up to 32x for noise reduction
• Conversion trigger by I²C or dedicated INT pin
• Optimized I²C interface with cyclic redundancy check (CRC):
  • Maximum 1-MHz I²C clock speed
  • Special I²C frame reads for improved throughput
  • Factory-programmed and user-configurable I²C addresses
• Integrated temperature compensation for multiple magnet types
• Built-in temperature sensor
• 1.7-V to 3.6-V supply voltage VCC range
• Operating temperature range: -40℃ to +125℃

• Electricity meters
• Electronic smart lock
• Smart thermostat
• Joystick & gaming controllers
• Drone payload control
• Door & window sensor
• Magnetic proximity sensor
• Mobile robot motor control
• E-bike