ADI AD8335ACPZ

The AD8335 is a quad variable gain amplifier (VGA) with low noise preamplifier intended for cost and power sensitive applications. Each channel features a gain range of 48 dB, fully differential signal paths, active input preamplifier matching, and user-selectable maximum gains of 46 dB and 38 dB. Individual gain controls are provided for each channel. The preamplifier (PrA) has a single-ended to differential gain of ×8 (18.06 dB) and accepts input signals ≤625 mV p-p. PrA noise is 1.2 nV/√Hz and the combined input referred voltage noise of the PrA and VGA is 1.3 nV/√Hz at maximum gain. Assuming a 20 MHz noise bandwidth (NBW), the Nyquist frequency for a 40 MHz ADC, the input SNR is 92 dB. The HLxx pin optimizes the output SNR for 10-bit and 12-bit ADCs with 1 V p-p or 2 V p-p full-scale (FS) inputs. Channel 1 and Channel 2 are enabled through the EN12 pin, and Channel 3 and Channel 4 are enabled through the EN34 pin. For VGA only applications, the PrAs can be powered down, significantly reducing power consumption. The AD8335 is available in a 64-lead lead frame chip scale package (9 mm×9 mm) for the industrial temperature range of -40°C to +85°C.

• Low noise preamplifier (PrA)
• Voltage noise μ = 1.3 nV/√Hz typical
• Current noise = 2.4 pA/√Hz typical
• NF = 7 dB (Rs = R1N = 50 Ω)
• Single-ended input; VIN maximum = 625 mV p-p
• Active input match
• Input SNR (noise bandwidth = 20 MHz) = 92 dB
• VGA Differential output VOUT maximum = 5 V p-p, RL = 500 Ω differential
• Gain range (8 dB output gain step) −10 dB to ±38 dB—low gain mode; −2 dB to +46 dB—high gain mode
• Accurate linear-in-dB gain control
• PrA + VGA performance −3 dB bandwidth of 85 MHz
• Excellent overload performance
• Supply: 5 V
• Power consumption 95 mW/channel (380 mW total); 65 mW/channel (PrA off; 260 mW total)
• Power-down

• Medical imaging (ultrasound, gamma cameras)
• Sonar
• Test and measurement
• Precise, stable wideband gain control