ST ST7FLIT19F1M6TR

The ST7LITE1 is a member of the ST7 microcontroller family. All ST7 devices are based on a common industry-standard 8-bit core, featuring an enhanced instruction set. The ST7LITE1 features FLASH memory with byte-by-byte In-Circuit Programming (ICP) and InApplication Programming (IAP) capability. Under software control, the ST7LITE1 device can be placed in WAIT, SLOW, or HALT mode, reducing power consumption when the application is in idle or standby state. The enhanced instruction set and addressing modes of the ST7 offer both power and flexibility to software developers, enabling the design of highly efficient and compact application code. In addition to standard 8-bit data management, all ST7 microcontrollers feature true bit manipulation, 8x8 unsigned multiplication and indirect addressing modes. The devices feature an on-chip Debug Module (DM) to support in-circuit debugging (ICD).

• 4 Kbytes single voltage extended Flash (XFlash) Program memory with read-out protection, In-Circuit Programming and In-Application programming (ICP and IAP). 10K write/ erase cycles guaranteed, data retention: 20 years at 55℃
• 256 bytes RAM
• 128 bytes data E²PROM with read-out protection. 300K write/erase cycles guaranteed, data retention: 20 years at 55℃
• Enhanced reset system
• Enhanced low voltage supervisor (LVD) for main supply and an auxiliary voltage detector (AVD) with interrupt capability for implementing safe power-down procedures
• Clock sources: Internal 1% RC oscillator (on some devices), crystal/ceramic resonator or external clock
• Internal 32-MHz input clock for Auto-reload timer
• Optional x4 or x8 PLL for 4 or 8 MHz internal clock
• Five Power Saving Modes: Halt, Active-Halt, Auto Wake-up from Halt, Wait and Slow
• Up to 15 multifunctional bidirectional I/O lines
• 7 high sink outputs
• Configurable watchdog timer
• Two 8-bit Lite Timers with prescaler
• 1 realtime base and 1 input capture
• One 12-bit Auto-reload Timer with 4 PWM outputs, input capture and output compare functions
• SPI synchronous serial interface
• 10 interrupt vectors plus TRAP and RESET
• 15 external interrupt lines (on 4 vectors)
• 7 input channels
• Fixed gain Op-amp
• 13-bit precision for 0 to 430 mV (at 5V VDD)
• 10-bit precision for 430 mV to 5V (at 5V VDD)
• 8-bit data manipulation
• 63 basic instructions with illegal opcode detection
• 17 main addressing modes
• 8x8 unsigned multiply instructions
• Full hardware/software development package
• DM (Debug Module)