MICROCHIP PL133-67OC

1:6 LVCMOS output fanout buffer for DC to 150MHz 8mA Output Drive Strength Low power consumption for portable applications. Low input-output delay Output-Output skew less than 250ps Low Additive Phase Jitter of 60fs RMS 2.5V to 3.3V, ±10% operation Operating temperature range from -40°C to 85°C Available in 16-Pin SOP GREEN/RoHS package. The PL133-67 is an advanced fanout buffer design for high performance, low-power, small form factor applications. The PL133-67 accepts a reference clock input from DC to 150MHz and provides 6 outputs of the same frequency. The PL133-67 is offered in a TSSOP-16L package and it offers the best phase noise, additive jitter performance, and lowest power consumption of any comparable IC. The PL133-67 outputs can be disabled to a high impedance (tri-state) by pulling low the OE pin. When the OE pin is high, the outputs are enabled and follow the REF input signal. When the OE pin is left open, a pull-up resistor on the chip will default the OE pin to logic 1 so the outputs are enabled.

• 1:6 LVCMOS output fanout buffer for DC to 150MHz
• 8mA Output Drive Strength
• Low power consumption for portable applications
• Low input-output delay
• Output-Output skew less than 250ps
• Low Additive Phase Jitter of 60fs RMS
• 2.5V to 3.3V, ±10% operation
• Operating temperature range from -40°C to 85°C
• Available in 16-Pin SOP GREEN/RoHS package
• The PL133-67 is an advanced fanout buffer design for high performance, low-power, small form factor applications
• The PL133-67 accepts a reference clock input from DC to 150MHz and provides 6 outputs of the same frequency
• The PL133-67 is offered in a TSSOP-16L package and it offers the best phase noise, additive jitter performance, and lowest power consumption of any comparable IC
• The PL133-67 outputs can be disabled to a high impedance (tri-state) by pulling low the OE pin. When the OE pin is high, the outputs are enabled and follow the REF input signal. When the OE pin is left open, a pull-up resistor on the chip will default the OE pin to logic 1 so the outputs are enabled