MICROCHIP ATTINY167-MMU

The ATtiny87/167 is a low power, CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. The ATtiny87/167 is a 20/32-pins device with 8/16 KB Flash, 512 bytes SRAM and 512 bytes EEPROM. By executing instructions in a single clock cycle, the devices achieve CPU throughput approaching one million instructions per second (MIPS) per megahertz, allowing the system designer to optimize power consumption versus processing speed.

• High Performance, Low Power AVR 8-bit Microcontroller
• Advanced RISC Architecture
  • 123 Powerful Instructions
  • Most Single Clock Cycle Execution
  • 32x8 General Purpose Working Registers
  • Fully Static Operation
• Non-volatile Program and Data Memories
  • 8K/16K Bytes of In-System Programmable Flash Program Memory
    • Endurance: 10,000 Write/Erase Cycles
  • 512 Bytes of In-System Programmable EEPROM
    • Endurance: 100,000 Write/Erase Cycles
  • 512 Bytes of Internal SRAM
  • Data retention: 20 Years at 85℃ / 100 Years at 25℃
  • In-System Programmable via SPI Port
  • Low size LIN/UART Software In-System Programmable
  • Programming Lock for Software Security
• Peripheral Features
  • LIN 2.1 and 1.3 Controller or 8-bit UART
  • One 8-bit Asynchronous Timer/Counter with Prescaler
    • Output Compare or 8-bit PWM Channel
  • One 16-bit Synchronous Timer/Counter with Prescaler
    • External Event Counter
    • 2 Output Compare Units or PWM Channels each Driving up to 4 Output Pins
  • Master/Slave SPI Serial Interface
  • Universal Serial Interface with Start Condition Detector
  • 10-bit ADC
    • 11 Single Ended Channels
    • 8 Differential ADC Channel Pairs with Programmable Gain (8x or 20x)
  • On-chip Analog Comparator with Selectable Voltage Reference
  • 100 μA ±10% Current Source for LIN Node Identification
  • On-chip Temperature Sensor
  • Programmable Watchdog Timer with Separate On-chip Oscillator
• Special Microcontroller Features
  • Software Controlled Clock Switching for Power Control, EMC Reduction
  • debugWIRE On-chip Debug System
  • External and Internal Interrupt Sources
  • Low Power Idle, ADC Noise Reduction, and Power-down Modes
  • Power-on Reset and Programmable Brown-out Detection
  • Internal 8MHz Calibrated Oscillator
  • 4-16 MHz and 32 KHz Crystal/Ceramic Resonator Oscillators
• I/O and Packages
  • 16 Programmable I/O Lines
  • 20-pin SOIC, 32-pad VQFN and 20-pin TSSOP
  • Operating Voltage:
    • 1.8 – 5.5V for ATtiny87/167
  • Speed Grade:
    • 0 – 4 MHz @ 1.8 – 5.5V
    • 0 – 8 MHz @ 2.7 – 5.5V
    • 0 – 16 MHz @ 4.5 – 5.5V
  • Industrial Temperature Range