LCSC Electronics logoLCSC Electronics svg logo
Anmelden
USD
Warenkorb
ADI LT1078ISW#TRPBF product image
Abbildung ähnlich

ADI LT1078ISW#TRPBF

Hersteller
ADI
Herst.-Teilenr.
LT1078ISW#TRPBF
LCSC-Nr.
C661730
Verp.
SOIC-16-300mil
Kundennummer
Hauptmerkm.
5mA 2 60uV 0.07V/us 108dB 6nA 200kHz 39uA SOIC-16-300mil Instrumentation, Op Amps, Buffer Amps RoHS
DatenblattADI LT1078ISW#TRPBF
RoHS-Konformität1 Dokumente verfügbar
Garantie auf jede Bestellung
100% Authentisch · 30-Tage-Rückgabe oder -Umtausch
Nicht vorrätig
Benachrichtigen
Minimum: 1Vielfaches: 1Verkaufseinheit: Piece
Zur BOM-Liste hinzufügen
Stk.E-Preis(Nur als Referenz)Gesamtbetrag
1+$ 5.339$ 5.34
10+$ 4.5959$ 45.96
30+$ 4.1426$ 124.28
100+$ 3.7633$ 376.33
Standardgehäuse1000/Full Reel
Besserer Preis bei größerer Menge?
$

Produktspezifikationen

Alle
TypBeschreibung
KategorieIntegrated Circuits (ICs)/Linear/Amplifiers/Instrumentation, Op Amps, Buffer Amps
HerstellerADI
Verp.SOIC-16-300mil
Output Current5mA
Number of Channels2
Vos - Input Offset Voltage60uV
Slew Rate0.07V/us
Input Offset Current(Ios)50pA
Operating Temperature-40℃~+85℃
Common Mode Rejection Ratio(CMRR)108dB
Ib - Input Bias Current6nA
Input Offset Voltage Drift(Vos TC)500nV/℃
Gain Bandwidth Product200kHz
Quiescent Current39uA
FeaturesReverse-phase input protection
Input Voltage Noise Density28nV/√Hz@1kHz
Dual Supply-
Rail to Rail-
Single Supply2.3V~12V
Hilfe & FeedbackÄhnliche Produkte anzeigen (0) >

Beschreibung

KI-Übersetzung

The LT1078 is a micropower dual op amp in 8-pin packages including the small outline surface mount package. The LT1079 is a micropower quad op amp offered in the standard 14-pin packages. Both devices are optimized for single supply operation at 5V. ±15V specifications are also provided. Micropower performance of competing devices is achieved at the expense of seriously degrading precision, noise, speed and output drive specifications. The design effort of the LT1078/LT1079 was concentrated on reducing supply current without sacrificing other parameters. The offset voltage achieved is the lowest on any dual or quad nonchopper stabilized op amp—micropower or otherwise. Offset current, voltage and current noise, slew rate and gain bandwidth product are all two to ten times better than on previous micropower op amps. The 1/f corner of the voltage noise spectrum is at 0.7Hz, at least three times lower than on any monolithic op amp. This results in low frequency (0.1Hz to 10Hz) noise performance which can only be found on devices with an order of magnitude higher supply current. Both the LT1078 and LT1079 can be operated from a single supply (as low as one lithium cell or two Ni-Cad batteries). The input range goes below ground. The allNPN output stage swings to within a few millivolts of ground while sinking current—no power consuming pull down resistors are needed.

Merkmale

KI-Übersetzung
  • Available in 8-Pin SO Package
  • 50μA Max Supply Current per Amplifier
  • 70μV Max Offset Voltage
  • 180μV Max Offset Voltage in 8-Pin SO
  • 250pA Max Offset Current
  • 0.6μVP-P, 0.1Hz to 10Hz Voltage Noise
  • 3pAP-P, 0.1Hz to 10Hz Current Noise
  • 0.4μV/°C Offset Voltage Drift
  • 200kHz Gain Bandwidth Product
  • 0.07V/μs Slew Rate
  • Single Supply Operation
  • Input Voltage Range Includes Ground
  • Output Swings to Ground while Sinking Current
  • No Pull-Down Resistors Needed
  • Output Sources and Sinks 5mA Load Current

Anwendungen

KI-Übersetzung
  • Battery or Solar-Powered Systems
  • Portable Instrumentation
  • Remote Sensor Amplifier
  • Micropower Sample-and-Hold
  • Thermocouple Amplifier
  • Micropower Filters