LCSC Electronics logoLCSC Electronics svg logo
Connexion
USD

MICROCHIP PIC18F45J10-I/PT

Fabricant
Réf. Fab.
PIC18F45J10-I/PT
Réf. LCSC
C11332
Condit.
TQFP-44(10x10)
Numéro Client
Caract. clés
Pin High-Performance RISC Microcontrollers with nanoWatt Technology
Fiche TechniqueMICROCHIP PIC18F45J10-I/PT
Conformité RoHS2 documents disponibles
Pièces alternatives3
Garantie sur chaque commande
100% Authentique · Retour ou échange sous 30 Jours

Spécifications du Produit

Tout
TypeDescription
CatégorieIntegrated Circuits (ICs)/Embedded/Microcontrollers
FabricantMICROCHIP
Condit.TQFP-44(10x10)
ADC (Bit)10bit
Number of I/O32
Operating Temperature-40℃~+85℃
Voltage - Supply2.7V~3.6V
Program Memory TypeFLASH
EEPROM-
Program Storage Size32KB
CPU CorePIC
Core Size8 Bit
CPU Maximum Speed40MHz
Oscillator TypeBuilt-in

Caractéristiques

Traduction par IA
  • Operating voltage range: 2.0V to 3.6V
  • 5.5V tolerant inputs (digital pins only)
  • On-chip 2.5V voltage regulator
  • Low-power, high-speed CMOS Flash technology
  • C compiler optimized architecture:
    • Optional extended instruction set designed to optimize re-entrant code
    • Interrupt priority levels
    • 8×8 single-cycle hardware multiplier
  • Enhanced Watchdog Timer (WDT):
    • Programmable period from 4 ms to 131s
  • Single-supply In-Circuit Serial Programming (ICSP) via two pins
  • In-Circuit Debugging (ICD) via two pins with three breakpoints
  • Power management modes:
    • Run: CPU on, peripherals on
    • Idle: CPU off, peripherals on
    • Sleep: CPU off, peripherals off
  • Flexible oscillator structure:
    • Two crystal modes up to 40 MHz
    • Two external clock modes up to 40 MHz
    • Internal 31 kHz oscillator
    • Secondary oscillator using Timer1 @ 32 kHz
    • Two-speed oscillator start-up
    • Fail-Safe Clock Monitor: allows safe shutdown if peripheral clock stops
  • Peripheral highlights:
    • High-current sink/source 25 mA/25 mA (PORTB and PORTC)
    • Three programmable external interrupts
    • Four input change interrupts
    • One Capture/Compare/PWM (CCP) module
    • One Enhanced Capture/Compare/PWM (ECCP) module:
      • One, two, or four PWM outputs
      • Selectable polarity
      • Programmable dead-band time
      • Auto-shutdown and auto-restart
    • Two Master Synchronous Serial Port (MSSP) modules supporting 3-wire SPI (all 4 modes) and I²C master/slave mode
    • One Enhanced Addressable USART module:
      • Supports RS-485, RS-232, and LIN 1.2
      • Auto-wake-up on Start bit
      • Auto-baud rate detection
    • 10-bit, up to 13-channel Analog-to-Digital Converter (A/D) module:
      • Auto-acquisition capability
      • Conversion during Sleep
      • Auto-calibration
    • Dual analog comparators with input multiplexing