LCSC Electronics logoLCSC Electronics svg logo
Entrar
USD

TI LMX2594RHAR

Fabricante
Cód. da peça
LMX2594RHAR
Nº LCSC
C2862572
Emb.
VQFN-40-EP(6x6)
Número do Cliente
Atrib. princ.
15GHz wideband PLL RF synthesizer
Folha de DadosTI LMX2594RHAR
Conformidade RoHS2 documentos disponíveis
Garantia em cada pedido
100% Autêntico · Devolução ou Substituição em 30 Dias

Especificações do Produto

Tudo
TipoDescrição
CategoriaIntegrated Circuits (ICs)/Clock/Timing/Clock Generators, PLLs, Frequency Synthesizers
FabricanteTI
Emb.VQFN-40-EP(6x6)
Operating Temperature-40℃~+85℃
Clock/OscillatorExternal
Output Frequency(Max)15GHz
Voltage - Supply3.15V~3.45V
Period Jitter, Peak-to-Peak-;-
InterfaceSPI
Phase OffsetSupport
FeaturesOn-chip VCO/DCO;Built-in phase-locked loop;Output synchronization and phase alignment;Protocol-specific clock generation
Input-
Output Level-
Phase Jitter45fs
Number of Outputs2

Descrição

Tradução por IA

The LMX2594 is a high-performance wideband synthesizer that can generate any frequency in the range of 10 MHz to 15 GHz without using an internal doubler, thus eliminating the need for sub-harmonic filters. A high-performance PLL with a figure of merit of -236 dBc/Hz and a high phase detector frequency enable very low in-band noise and integrated jitter. The high-speed N-divider has no prescaler, significantly reducing the amplitude and number of spurs. There is also a programmable input multiplier that can mitigate integer boundary spurs. The LMX2594 allows users to synchronize the outputs of multiple devices and can be applied when a specific delay is required between the input and output. The frequency ramp generator can synthesize up to 2 segments of ramps in either the automatic ramp generation option or the manual option for maximum flexibility. The frequency can be accelerated to over 20 µs through a fast calibration algorithm. The LMX2594 adds support for generating or repeating SYSREF (compliant with JESD204B), which is an ideal low-noise clock source for high-speed data converters. Fine delay adjustment (9 ps resolution) is provided in this configuration to address the delay differences of board traces. The output driver in the LMX2594 provides an output power of up to 7 dBm at a carrier frequency of 15 GHz. The device is powered by a single 3.3 V supply and has an integrated LDO, eliminating the need for an on-board low-noise LDO.

Recursos

Tradução por IA
  • 10MHz to 15GHz output frequency
  • Phase noise of -110dBc/Hz at 100KHz offset and 15GHz carrier
  • 45fs rms jitter (100Hz to 100MHz) at 7.5GHz
  • Programmable output power
  • PLL figure of merit: -236dBc/Hz
  • Nominal 1/f noise: -129dBc/Hz
  • Maximum phase detector frequency:
    • 400MHz integer mode
    • 300MHz fractional mode
  • 32-bit fractional-N divider
  • Programmable input multiplier for integer boundary spur elimination
  • Output phase synchronization across multiple devices
  • SYSREF support with 9ps resolution programmable delay
  • Frequency ramp and chirp generation for FMCW applications
  • VCO calibration time less than 20µs
  • 3.3V single-supply operation

Aplicações

Tradução por IA
  • 5G and mmWave wireless infrastructure
  • Test and measurement equipment
  • Radar MIMO phased array antennas and beamforming
  • High-speed data converter clocking (JESD204B support)