MICROCHIP ATMEGA165PV-8AU

The ATmega165P is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega165P achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

• High Performance, Low Power Atmel AVR 8-Bit Microcontroller
• Advanced RISC Architecture
  • 130 Powerful Instructions
  • Most Single Clock Cycle Execution
  • 32x8 General Purpose Working Registers
  • Fully Static Operation
  • Up to 16 MIPS Throughput at 16 MHz
  • On-Chip 2-cycle Multiplier
• High Endurance Non-volatile Memory segments
  • 16 Kbytes of In-System Self-programmable Flash program memory
  • 512 Bytes EEPROM
  • 1 Kbytes Internal SRAM
  • Write/Erase cyles: 10,000 Flash/100,000 EEPROM
  • Data retention: 20 years at 85℃/100 years at 25℃
  • Optional Boot Code Section with Independent Lock Bits In-System Programming by On-chip Boot Program True Read-While-Write Operation
  • Programming Lock for Software Security
• JTAG (IEEE std. 1149.1 compliant) Interface
  • Boundary-scan Capabilities According to the JTAG Standard
  • Extensive On-chip Debug Support
  • Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
• Peripheral Features
  • Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode
  • One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode
  • Real Time Counter with Separate Oscillator
  • Four PWM Channels
  • 8-channel, 10-bit ADC
  • Programmable Serial USART
  • Master/Slave SPI Serial Interface
  • Universal Serial Interface with Start Condition Detector
  • Programmable Watchdog Timer with Separate On-chip Oscillator
  • On-chip Analog Comparator
  • Interrupt and Wake-up on Pin Change
• Special Microcontroller Features
  • Power-on Reset and Programmable Brown-out Detection
  • Internal Calibrated Oscillator
  • External and Internal Interrupt Sources
  • Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby
• I/O and Packages
  • 54 Programmable I/O Lines
  • 64-lead TQFP and 64-pad QFN/MLF
• Speed Grade
  • ATmega165PV: 0 - 4 MHz @ 1.8V - 5.5V, 0 - 8 MHz @ 2.7V - 5.5V
  • ATmega165P: 0 - 8 MHz @ 2.7V - 5.5V, 0 - 16 MHz @ 4.5V - 5.5V
• Temperature range: -40℃ to 85℃ Industrial
• Ultra-Low Power Consumption
  • Active Mode: 1 MHz, 1.8V: 330 μA; 32 kHz, 1.8V: 10 μA (including Oscillator)
  • Power-down Mode: 0.1 μA at 1.8V
  • Power-save Mode: 0.6 μA at 1.8V (Including 32 kHz RTC)