LCSC Electronics logoLCSC Electronics svg logo
로그인
USD

UMW SP3485EEN(UMW)

제조업체
UMWAsian Brands
제조사 품번
SP3485EEN(UMW)
LCSC 번호
C668205
포장
SOP-8
고객 번호
주요 제원
RS485/RS422 transceiver
데이터시트UMW SP3485EEN(UMW)
RoHS 준수3개 문서 이용 가능
대체 부품4
모든 주문 보장
100% 정품 · 30일 반품 또는 교환

제품 사양

전체
타입설명
카테고리Integrated Circuits (ICs)/Interface/Drivers, Receivers, Transceivers
제조업체UMW
포장SOP-8
Voltage - Supply2.97V~3.63V
TypeTransceiver
Data Rate12Mbps
Number of Nodes256
Operating Temperature-40℃~+85℃
Communication ModeHalf-Duplex
Number of Drivers1
FeaturesTx/Rx enable;Enable shutdown;Overcurrent Protection;Thermal shutdown protection;Low-power mode
Number of Receivers1
Quiescent Supply Current520uA
도움말 및 피드백유사 제품 보기 (0) >

개요

AI 번역

The SP3485E is a 3.3V-powered, half-duplex, low-power RS-485 transceiver that fully complies with TIA/EIA-485 standard requirements. The SP3485E integrates one driver and one receiver, both of which can be independently enabled and disabled. When both are disabled, the driver and receiver outputs enter a high-impedance state. The SP3485E features 1/8 unit load, allowing up to 256 SP3485E transceivers to be connected to the same communication bus. Error-free data transmission at up to 12Mbps is achievable. The SP3485E operates over a supply voltage range of 3.0V to 3.6V, and provides fault protection, over-temperature protection, current limiting protection, and overvoltage protection.

주요 특징

AI 번역
  • 3.3V supply, half-duplex
  • 1/8 unit load, supports up to 256 devices on the bus
  • Driver output short-circuit protection
  • Over-temperature protection
  • Low-power shutdown
  • Receiver open-circuit protection
  • High noise immunity
  • Integrated transient voltage suppression

응용 분야

AI 번역
  • Bus Networking: The SP3485E RS485 transceiver is designed for bidirectional data communication on multipoint bus transmission lines. These devices can also be used as line repeaters for cable lengths exceeding 4000 feet. To reduce reflections, termination matching using the characteristic impedance should be applied at both ends of the transmission line, and stub lengths beyond the main line should be kept as short as possible.
  • Daisy-Chain Networking: Also known as daisy-chain topology, this is the standard and recommended RS485 bus wiring topology endorsed by organizations such as TIA. The wiring method connects a master device and multiple slave devices in a daisy-chain configuration. This approach has no stubs, offering the advantages of low signal reflection and high communication success rate.
  • Bus Port Protection: In harsh environments, RS485 communication ports typically require protection against ESD, lightning, and surge, and may even need to withstand 380V power line contact, to prevent damage to smart meters and industrial control hosts.