LCSC Electronics logoLCSC Electronics svg logo
Anmelden
USD

MAXIM MAX8740ETB

Hersteller
Herst.-Teilenr.
MAX8740ETB
LCSC-Nr.
C3186920
Verp.
TDFN-10-EP(3x3)
Kundennummer
Hauptmerkm.
TFT-LCD Step-Up DC-DC Converter
DatenblattMAXIM MAX8740ETB
RoHS-Konformität2 Dokumente verfügbar
Garantie auf jede Bestellung
100% Authentisch · 30-Tage-Rückgabe oder -Umtausch

Produktspezifikationen

Alle
TypBeschreibung
KategorieIntegrated Circuits (ICs)/Power Management (PMIC)/Special Purpose Regulators
HerstellerMAXIM
Verp.TDFN-10-EP(3x3)
Synchronous RectifierNo
FeaturesAdjustable soft-start;External compensation;Light load efficient mode
Frequency - Switching640kHz~1.2MHz
FunctionBoost
Number of Outputs1
Output Voltage2.6V~28V
TopologyBoost
Output Current-
Quiescent Current220uA
Switch tube (built-in/external)Built-in
Operating Temperature-40℃~+85℃
Output TypeAdjustable
Voltage - Supply2.6V~5.5V

Beschreibung

KI-Übersetzung

The MAX8740 is a high-performance, step-up DC-DC converter that provides a regulated supply voltage for active-matrix, thin-film transistor (TFT), liquid-crystal displays (LCDs). The MAX8740 incorporates currentmode, fixed-frequency, pulse-width modulation (PWM) circuitry with a built-in n-channel power MOSFET to achieve high efficiency and fast transient response. The MAX8740 is a highly efficient power supply that employs a current-mode, fixed-frequency, PWM architecture for fast transient response and low-noise operation. The device regulates the output voltage through a combination of an error amplifier, two comparators, and several signal generators. The error amplifier compares the signal at FB to 1.24V and varies the COMP output. The voltage at COMP determines the current trip point each time the internal MOSFET turns on. As the load changes, the error amplifier sources or sinks current to the COMP output to command the inductor peak current necessary to service the load. To maintain stability at high duty cycles, a slope-compensation signal is summed with the current-sense signal. At light loads, this architecture allows the MAX8740 to “skip” cycles to prevent overcharging the output voltage. In this region of operation, the inductor ramps up to a peak value of approximately 150mA, discharges to the output, and waits until another pulse is needed again.

Merkmale

KI-Übersetzung
  • 90% Efficiency
  • Adjustable Output from VIN to 28V
  • 2.6V to 5.5V Input Supply Range
  • Input Supply Undervoltage Lockout
  • Pin-Programmable 640kHz/1.2MHz Switching Frequency
  • Programmable Soft-Start
  • 0.1μA Shutdown Current
  • Small, 10-Pin Thin DFN Package

Anwendungen

KI-Übersetzung
  • Notebook Computer Displays
  • LCD Monitor Panels